7 ways to keep your air conditioner humming

If you want to spend two or three super-heated days without any air conditioning, call for service on your AC system only when it acts up.

This summer, prevent a breakdown during the blistering heat by contacting a service tech – one who’s licensed, insured, bonded and recommended by someone you trust – to give your unit a once-over and fix any problems waiting to grow into something more expensive, inconvenient and uncomfortable.

Here are a few ways you can keep your air conditioning humming.

» Don’t run the fan in the “on” position. A thermostat has two settings: on and automatic. In the on position, the fan will run constantly all day and night. On auto, the indoor blower will come on only when the compressor comes on.

An air conditioner removes humidity from your indoor air. If you leave the fan turned on when the compressor turns off, it will blow that humidity back into the house.

If the humidity is low outside, you can run your fan all you want. But for much of the country, a constantly running fan can make indoor air downright uncomfortable.

» Change the AC filter every month. Even if the manufacturer’s instructions say change it once a season, do it every 30 days just like with your furnace filter.

Especially in windy locales, filters clog quickly with dust, hair and debris. Once that happens, air can’t flow freely through the filter to the coil.

If air to the coil is restricted, it won’t transfer heat or deal with humidity. That not only makes the house uncomfortable, it can damage the air-conditioning system and cost you plenty. Don’t use a $1 fiberglass filter. Choose a 1-inch pleated filter for about $4. And stay away from the $17 to $25 pleated filter.

Sure, the expensive filters catch just about every speck of dust that tries to pass through to the coil, but they provide so much resistance that even air can’t get through. That can starve your unit for air.

> Don’t crank the thermostat up when you’re leaving the house for the day. It’s true that the house doesn’t need to be as cool when nobody’s in it. But when a house gets too warm, it heats up not only the air, but the furniture, carpet and everything else in the house.

When you return home after work – at one of the hottest times of the day – and dip the temperature way down to get comfortable, the air conditioner has to cool the air, the furniture, the rugs all over again.

That’s going to cost more than the money you saved by turning the dial up. Your best bet is to install a programmable thermostat that consistently fluctuates the temperature every day by only two or three degrees.

» Never run the evaporative cooler – if you have one – on the same day as you run your air-conditioner. The air conditioner dehumidifies your indoor air; an evaporative cooler, common in dry climates, adds humidity.

So they’re natural-born enemies. Humidity reduces the effectiveness of your AC by as much as 20 percent.

Most people who have evaporative coolers like to run them in the morning when it’s a little cooler outdoors, and then switch to air conditioning when it heats up later in the day.

If you do that, you’ll waste energy.

> Notice any changes in the way your system sounds, if it vibrates or how much air it pushes out. You live with that unit, so you know it better than anybody. When you see, feel or hear changes, something’s wrong. Call the service tech while the problem is new and fixable.

> If you have your unit repaired, ask the technician to leave you any old parts that they replace. You’re more likely to avoid falling victim to a common scam by unscrupulous contractors who will tell you that your unit or some of its parts have failed when they haven’t.

Some air-conditioning companies require their techs to meet quotas by selling a certain amount of replacement parts whether the customers need them or not. Others pay techs a commission on replacement parts, which can tempt them to lie to homeowners about the condition of their systems.

Your best bet is to do your homework before inviting an AC tech into your home. Find out how long the company has been in business in your area and whether the tech has a state license.

Ask to see proof of insurance and bonding. And always go with someone who comes highly recommended by someone you trust.

> Find out how old your system is. Most last about 15 years. If yours is getting up there in years, plan to replace it.

A qualified service tech can evaluate the system and give you an idea of how much longer it has. If you decide to hang onto it until it dies, be prepared by choosing and consulting with a trusted company and selecting your replacement unit ahead of time.

That way, you won’t have to make these expensive decisions during an emergency in the middle of the summer – and you’re likely to get better equipment, a better price and a better installation job.

 

http://www.coloradoan.com/

Furnasman

http://Furnasman.com/

8 Ways To Avoid Air-Conditioning Trouble

110728093829 heathotweather 8 Ways To Avoid Air Conditioning Trouble

If you want to spend two or three super-heated days without any air conditioning, call for service on your AC system only when it acts up.

This summer, prevent a breakdown during the blistering heat by contacting a service tech — one who’s licensed, insured, bonded and recommended by someone you trust — to give your unit a once-over and fix any little problems that are waiting to grow into something more expensive, inconvenient and uncomfortable.

Here are a few other ways you can keep your air conditioning humming.

1. Don’t run the fan in the “on” position.

A thermostat has two settings: on and automatic. In the on position, the fan will run constantly all day and night. On auto, the indoor blower will come on only when the compressor comes on.

An air conditioner removes humidity from your indoor air. If you leave the fan turned on when the compressor turns off, it will blow that humidity back into the house.
If the humidity is low outside, you can run your fan all you want. But for much of the country, a constantly running fan can make indoor air downright uncomfortable.

2. Change the AC filter every month.

Even if the manufacturer’s instructions say change it once a season, do it every 30 days just like with your furnace filter.

Especially in windy locales, filters clog quickly with dust, hair and debris. Once that happens, air can’t flow freely through the filter to the coil.

If air to the coil is restricted, it won’t transfer heat or deal with humidity. That not only makes the house uncomfortable, it can damage the air-conditioning system and cost you plenty.

A tip:@ Don’t use a $1 fiberglass filter. Choose a 1-inch pleated filter for about $4. And stay away from the $17 to $25 pleated filter.

Sure, the expensive filters catch just about every speck of dust that tries to pass through to the coil, but they provide so much resistance that even air can’t get through. That can starve your unit for air.

3. Don’t crank the thermostat up when you’re leaving the house for the day.

It’s true that the house doesn’t need to be as cool when nobody’s in it. But when a house gets too warm, it heats up not only the air, but the furniture, carpet and everything else in the house.

When you return home after work — at one of the hottest times of the day — and dip the temperature way down to get comfortable, the air conditioner has to cool the air, the furniture, the rugs all over again.

That’s going to cost more than the money you saved by turning the dial up. Best bet: Install a programmable thermostat that consistently fluctuates the temperature every day by only two or three degrees.

4. Never run the evaporative cooler — if you have one — on the same day as you run your air-conditioner.

The air conditioner dehumidifies your indoor air; an evaporative cooler, common in dry climates, adds humidity.

So they’re natural-born enemies. Humidity reduces the effectiveness of your AC by as much as 20 percent.

Most people who have evaporative coolers like to run them in the morning when it’s a little cooler outdoors, and then switch to air conditioning when it heats up later in the day.

If you do that, you’ll waste energy.

5. Watch your secondary drain.

If you have a split-system air conditioner — part of the unit is in the attic and part is outside on the ground — you probably have two drains coming out of the house: one near the ground and one on the wall.

The one on the wall is the secondary drain. The only time water comes out of it is if the primary drain — the one on the ground — is clogged. This is an emergency. Call your AC tech to clean out that drain.

6. Notice any changes in the way your system sounds, if it vibrates or how much air it pushes out.

You live with that unit, so you know it better than anybody. When you see, feel or hear changes, something’s wrong.

Call the service tech while the problem is new and fixable.

7. If you have your unit repaired, ask the technician to leave you any old parts that he replaces.

You’re more likely to avoid falling victim to a common scam by unscrupulous contractors who will tell you that your unit or some of its parts have failed when they haven’t.

Some air-conditioning companies require their techs to meet quotas by selling a certain amount of replacement parts whether the customers need them or not. Others pay techs a commission on replacement parts, which can tempt them to lie to homeowners about the condition of their systems.

Your best bet: Do your homework before inviting an AC tech into your home. Find out how long the company has been in business in your area and whether the tech has a state license.

Ask to see proof of insurance and bonding. And always go with someone who comes highly recommended by someone you trust.

8. Find out how old your system is.

Most last for about 15 years. If yours is getting up there in years, plan to replace it.

A qualified service tech can evaluate the system and give you an idea of how much longer it has. If you decide to hang onto it until it dies, be prepared by choosing and consulting with a trusted company and selecting your replacement unit ahead of time.

That way, you won’t have to make these expensive decisions during an emergency in the middle of the summer — and you’re likely to get better equipment, a better price and a better installation job.

 

http://wusa9.com/

Furnasman

http://Furnasman.com/

Heating Repair – Do It Yourself Or Not?

Sometimes you can handle heating repair tasks on your own, but other times your safety is at risk if you do. Learn when you need to hire a professional and when you can safely tackle something as a DIY project.

Heating repair is one form of home improvement that you need to be very careful with. Some aspects of your HVAC system you can easily fix on your own, but others are best left to a professional. As a good rule of thumb, if you are not confident in your ability to fix something, you should not do so.

Safe to Do Yourself

Some tasks are tasks the average homeowner can handle. For instance, changing the furnace filter in your unit takes just a few minutes and requires no special skill. Simply remove the old filter and replace it with a new one. You can also vacuum or brush the heat exchanger surfaces once per year. Just remember to power off the unit before performing these maintenance tasks.

Replacing a thermostat is another task that you might be able to handle on your own, if you are comfortable working with wiring. You may also be able to light the pilot light on your unit if it goes out. Before doing either of these somewhat simple tasks, check with the owner’s manual for your HVAC system, and follow all instructions carefully.

Repairs That Need a Professional

Sometimes you are safer if you hire a professional to deal with your heating repair needs. No matter what the situation, if you are unsure about the safest way to do something, call in a pro. However, certain situations almost always require the skill of a trained, licensed contractor.

If your furnace stops working, take the time to troubleshoot the situation before calling in a professional. Make sure the thermostat is set properly, and check to see that the pilot light is lit if the model has one. Check the batteries in your thermostat as well. If the furnace has an electrical switch that turns it on and off, make sure it is on. If you have an oil burner, check the oil levels. If none of these situations are the cause of the problem, then you need a professional contractor to look at the unit and determine what is wrong. Attempting to fix other situations in your furnace could put your safety at risk.

If you need to add ductwork or adjust the layout of your ductwork in your furnace system, consider at least consulting with a professional. Failure to install ductwork properly could lead to energy loss through leaks in the system.

Finally, if you have determined that heating repair is not the answer, but rather you need to install a new furnace or HVAC system, you must use a licensed professional. Doing so ensures that the job is done to code and your family is safe. It also ensures you will not run into problems when it comes time to sell your property.

Finding the Right Contractor

When you need heating repair services, take the time to find a highly recommended contractor. Ask others who have had heating work done, or look at reviews on third-party websites. These resources will help you find a contractor with excellent skills and a solid reputation.


http://www.azecobuilding.com/



Furnasman



http://Furnasman.com/

Guidelines for a Home Furnace Maintenance

During winter season, a home furnace is very helpful to keep the house warm, snug and comfortable. This lets the family relax and be comfortable even when it is freezing outside. That is why a home furnace should be properly & regularly maintained.

Actually, maintaining a home furnace is really easy. There are just few simple measures to be considered to keep the furnace in good working condition. Below are some basic yet effective guidelines on how to maintain the good condition of your home furnace.

Before the weather gets cold, check on your furnace and ensure that no parts are malfunctioning. Doing so will prevent you from being stuck with a dysfunctional furnace and uncomfortable feeling during cold nights. Also, don’t forget to pay attention to the moving parts of the furnace such as chains and pulleys because they are the ones that easily get rust. It is essential to check all the parts and replace those that are faulty to avoid malfunction from occurring.

You must be aware that external particles like dust can have a major effect to your home furnace function. Dust particles can obstruct the pathway of smoke going outside likewise the path for the warm which is supposed to be sent inside your home. That is why keeping your home furnace clean is really important. Even at winter time, home furnace cleaning should be done on a regular basis. Another important reminder, when you are cleaning your furnace, make sure that your mouth and nose are covered. Also, your furnace must be switched off before your cleaning starts.

Different parts of your home furnace should be cleaned separately and thoroughly. On a monthly basis, the filter should be cleaned and the water which is settled in the pipe from snow and melted ice should be removed. Another thing to be given an attention is the opening for air supply because it is considered as one of the critical parts of a furnace. After cleaning all the furnace parts, all filth and grime that are collected should be removed to prevent them from re-entering the furnace.

High priority of maintenance should be given to the filter because an unclean filter can severely alter the function of the furnace. Also, if it is too dirty then it would be better to replace it with a new one.

Seeking help of a professional is also a good option for the purpose of cleaning and maintaining your furnace. Experts on this kind of device have tools to look after the more intricate details. At least once a year, involving the help of a professional is advisable.

Furnasman

http://www.furnasman.com/